Reply to Thread

Best Solution For A1200 Rest User Code

hi bro,
can you tell me what options do i have to check, to get usercode with radiocomm, as i dont understand how to do it

Best Solution For A1200 Rest User Code

OK then...

My A1200 phone gets connection but in Motorola USB Modem mode (blue Dot).
How can I change it to USB Composite Device mode (Green Dot) that is P2K test commands.

Please Help because i cant do the Master Reset.
The message board it shows letters with a red background and doesnt work.

Thanks in advance.
Regards.

Best Solution For A1200 Rest User Code

Radio Detection Status
In the upper right corner of RadioComm there is a Radio Detection status area. This area consists of a simple
colored circle to show the connection status of a radio. This status will be displayed only when either of the USB or
TCPIP over USB (BLAN) communication modes is selected.
Red Circle: This status means that no radio is detected.
Blue Circle: This status means that a radio is detected and in Motorola USB Modem mode. (AT commands or QC
test commands)
Green Circle: This status means that a radio is detected and in USB Composite Device mode. (Motorola P2K Test
Commands)
Yellow Circle: This status means that a radio is enumerated as a USB LAN device but the socket connection is not
yet successful. (Motorola P2K or QC test commands in USB LAN mode)
Pink Circle: This status means that a radio is enumerated as a USB LAN device and the socket connection was
successful. (Motorola P2K or QC test commands in USB LAN mode)
White Circle: This status means that a USB to RS232 converter is detected and can be setup for use for project D
phones.

Best Solution For A1200 Rest User Code

yes, advise me when link is ready

Best Solution For A1200 Rest User Code

I also have a problem with sms sending.I have instaled new firmware but it's not working sms sending.please helpppp...

Best Solution For A1200 Rest User Code

where is flasher for this file

i have motorola a1200 thats sms not working

Best Solution For A1200 Rest User Code

link not woking ...pleasse other server

Best Solution For A1200 Rest User Code

yes link not working

Best Solution For A1200 Rest User Code

thank you,

for those ones that didnt work,

i restarted the computer,
and conected the motorola a1200,
and after that, one important thing is to disable firewall, that is very important, after that all went ok,
opened radiocomm,
and when phone is conected the red dot in the right uper corner turns green,
that means phone is conected,
after that went to cit,
and selected invm,
and then the first option 00-mstr rst

then you have to hit execute that is down near the invm option,
when you hit execute, in the upper message board, the letters have to come out in green color, if it shows the background red color it is not well done,
after the master reset is done right, you just have to go to the upper center, besides the quared message board, where says reset,
when you hit reset the phone resets inmediately, and you will know all worked right,

after that the phone goes up without asking any password,

thanks to the guys that advised about radiocomm,

we are very glad with this info
*** bless you

Best Solution For A1200 Rest User Code

Radiocomm software can remove user lock ,But cant rest code to 1234,0000 or 000000