If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed.
Post a reply to the thread: I/O extender board and case for a cheap WiFi router
Click here to log in
What is the sum of 36 and 12
You may choose an icon for your message from this list
Will turn www.example.com into [URL]http://www.example.com[/URL].
You may rate this thread from 1-star (Terrible) to 5-stars (Excellent) if you wish to do so.
I/O extender board and case for a cheap WiFi router This 3d printed case houses the already small [TP-Link TL-WR703N] but also makes room for a custom expansion board. The expansion board is designed to make the device more hacker friendly, and who doesn’t need a nice case to hold it? Since the router board already has a USB port (intended for use with USB 3G modems) the add-on acts as a USB hub. The stock USB connector is replaced by a pin header which mates with a DIL socket on the underside of the expansion board. Through the use of an FTDI chip the expander offers three USB ports and a 2×10 pin header to break out the GPIO pins from the router’s processor. Only two USB ports are visible in the image above. That’s because the third is recessed, and an opening has not been added to the enclosure. This struck us as odd until we read that the port is meant to be used with a low-profile thumb drive, essentially adding internal storage for the device. [Thanks buZz] Filed under: wireless hacks
I/O extender board and case for a cheap WiFi router
Forum Rules
