Thread: X65 > v36, x70, x75 unlocking - STEP BY STEP!

"Connect your phone using DCA-500 or DCA-510 cable (DCA-540 is not supported!)."

is really needed an original siemens cable???

I guess your problem is the tolerance of the resistors.

I used some 1/4W resistors and I have had the same problem.

Used 0402 SMD 15k resistors from old 3210 PCB and all was ok

My cable also goes wild .... do you have a solution for this problem ?

Does the resistor "trick" work ???

I tried to connect with papuas ... also no chance

Hi!
Just to let you know:
The new px75v1 works with CX75 V11 vodafone (CXV7)!
Regards!

@eggwisher

Can't you see I wrote >v36?

@UnlockerPT

I didn't mean original cables, but phone has to recognise non-original cable as DCA-500 or DCA-510...

Hi mates,

Thanks mikee for testing.

here is the link to the latest x65 flasher(1091) and the above midlet. link

best regards,
Aishur

That's not a problem Take cable, plug to phone and start the midlet.
Wait for about 800sec. When it stops working and you'll see codes unplug the
cable and rewrite codes to PU manualy. You have to remember that u're putting HASH without "-" and ESN code turned out with bits, ex. your code is
A1D3-D4F5, you're put it like that: F5D4D3A1.


Greetings

Hi mates,
@amir-Skillz
My cables are regular ones based on the Pl 2303 chips (for ultra high speed flashing (driver patch required)) only I added two 10 k resistors with respect to Papua's diagram. Choice Типа DCA-5xx Авто "AT" end for the phone and ignore auto ignition .( Pin 1)
@Crumarix1
If i understood your question. you can find it here.
Best regards,
Aishur

@siemensiak.pl
thanks for sharing but steps from 12 to 18 can be replaced by only one step

br

@Chris02
for
UNLOCK
SIEMENS C75 v11
without px64v4 and without TestPoint
PapuaUtils v0.7.5c eng

CORECT OR NOT

1. Connect phone using DCA-500 or DCA-510 cable.
(cable c55_15k between 2-5 and 2-7pin)
2. Click