2 kicker l7 solo baric 12's and a hifonix bxi 2010 need amp-sub wiring help (with

[Patrick R]

links)? Okay i'm purchasing two kicker l7 12' solo-baric subwoofers.


# 12" subwoofer with dual 4-ohm voice coils
# SoloKon aluminum-treated composite cone with Santoprene surround
# cast-aluminum basket
# power range: 50-750 RMS watts (375 watts per voice coil)
# peak power: 1,500 watts
# frequency response: 20-100 Hz
# sensitivity: 88.84 dB
# mounting depth: 6-5/8"
# sealed box volume: 0.88-2.00 cubic feet
# ported box volume: 1.75-3.25 cu. ft.

These subwoofers are available in 2ohm, or 4ohm.

Now my amp.

Hifonics BXi 2010D.
# Brutus BXI Single-Channel Monoblock Super-D Class Car Amplifier
# RMS Power Rating:

* 4 ohms: 650 watts x 1 chan.
* 2 ohms: 1300 watts x 1 chan.
* 1 ohm: 2000 watts x 1 chan.

# MOSFET Power supply
# Super D-Class amplifier relies on a super-speed enhanced chip-set to produce higher current capacities and more precise digital to analog conversions
# Wired remote bass level control included
# Power and Protection LED indicators
# Built-in system diagnostics offer protection of DC, Speaker short, terminal, and overload
# Tuned Bass EQ (0-10 dB bass boost at 45 Hz)
# Dampening factor: >250
# Single-channel monoblock channel operation
# 1-Ohm stable
# Phase shift: 0-180 degrees
# Preamp RCA outputs
# Input level control: 0.04V - 18V
# Balanced line input for MX accessories and line drivers
# Heavy duty aluminum alloy heatsink for extreme heat dissipation
# RCA level inputs
# Screw terminals
# Variable low-pass filter (35-250 Hz, 24 dB/octave)
# Subsonic Filter (15-35 Hz at 24 dB)
# Frequency response: 35-250 Hz




Now my question to you guys is -
The amp is one channel, can i run both subs off of the one channel amp? And if so, what ways could they be wired? (links to pics, pros/cons, please)

- Should (with the amp i have chosen) purchase 2ohm, or 4ohm woofers?

Thanks folks and just let me know if there is any other information needed.
Please, reliable information guys. Not backyard mechanics.

[buddah]

no pics or diagrams, but yeah you can wire them series or parralel, if i am not mistaking eries will put them at 8 ohms, parralel will put them at 2 ohms and you can do that up to 4 speakers to make it 1 ohm, since its 1 ohm stable, but remember the higher the power and lower the ohms the more heat that gets generated