Thread: Unlocking C65 v43 - full solution

Works fine for unlock and imei change, i not use resirtor, only Jumper, but now the phone ons, get signal, 10 secnds later shut down itsles, black screnn, why its this fail???

Thanks
Work with m65 v43 too

Kjgsm

use our revolutinary software by nutzo version 10 - 15 to create map, upload map with Siemens Eeprom Tools 3.15, it works like A charm...

its not easy tho to do all the steps by papua, i had to hold the test point while my mate had to short red button and the other to click do jobs, but after everything you can actually enjoy a cigar and a cold mature beer

@Yashaka
you just forget to put the phone in normal mode before entering Skey
PHONE MUST BE ON TO ENTER SKEY

If you continue by this bad way with Eeprom tool just the first block will
be accepted by phone
and phone not powering on after (just beep) and you have just to Flash it then repair it with Papua by the fonction recalculate Keys in Flash
and to unlock it by the good way.

Thanks men, at least i got these compiled.

is first cx70
I didn't saw picture in forum and I asked
then I found pic for cx65

10x

BR
Rak|m

Hi, i used this solution, at "Enter Skey in phone" I turned on phone (without connected TP) and..:

Checking entry values.....
Test ServiceKey...
Enter ServiceKey in phone...
SKey enter !
Pause 1 second(s)...
SecurityStatus: FactoryMode

and nothing.. i tried one more time:

Checking entry values.....
Test ServiceKey...
Enter ServiceKey in phone...
No answer from phone !
Check com port number,cable,phone and MODE !

Now, phone doesn't turn on :/ What do I wrong?

I try it whit C65 v41 and it is working
thank`s for Kakrysa and a big thank you for pepik

Hi, usually this error is caused by 7 digit Skey (instead of 8 digit Skey),
you only have to edit log and add "zero" (0) at first position of skey.
f.ex. Skey: 5654327 = 05654327

it can't connect to eeprom tool