Programming BellTV Remotes

07-30-2010, 10:25 PM

Here's the Thread on IR interference:

http://www.digitalhome.ca/forum/showthread.php?t=64463

**MarkB** · 07-30-2010, 10:32 PM

Anyone know the code to work with a Pioneer 6010FD plasma. None of the codes in the book worked and I can't get it to work with the channel up step either.

07-30-2010, 11:08 PM

All the programming codes have 3 numbers. What code are you referring to? Thanks

07-30-2010, 11:32 PM

For the life of me, I cannot get my remote to recognize the receiver and I don't see any fixes on Bell's website. I programmed it to turn on the television, but it won't bring up the program guide/turn the receiver on or off. Any ideas? Been working fine for months, until now.

Thanks!

07-30-2010, 11:58 PM

Hi,

I just bought the a new LG 42PQ60 plasma TV (42 in). BTW, it was very nice TV!!

First, all of you know there's no LG TV into BEV user manual. But LG are the same brand than Goldstar, so I found a code who are working under Goldstar. BUT!! I can't switch the inputs on my TV with the BEV remote. So I have to use two remotes at a time (BEV + TV remote) and that's very annoying to me.

It probably doesn't make difference but my BEV receiver is a 9200 HD-PVR.

Does anybody have found a fully working code for the LG plasma's??

Thank you very much!!

07-30-2010, 11:59 PM

had the same problem... something in the way the remote was designed to control mulitple devices...

if you rent the reciever call BellTV and ask for a replacement...

if you own the reciever and its less then a year old, do the same and call BellTV....

if you've owned it longer then that (1yr) then look on marketplace websites and see if you can find a used one.

Best of Luck

07-31-2010, 12:07 AM

Many Yamaha (and some other) AVRs utilize discrete codes for the on/off function. Therefore the typical remote that comes with other equipment will not do this, since there is only one "power" button. This was mentioned in post 31, right above yours.

You'll need to consider a Harmony or similar remote to do this, or be satisfied with the volume functionality. Some remotes are "learning" remotes, in that they can be taught any command to any key, but I don't think the BTV remotes have this functionality?

Check out the following post, useful for those new to this forum - FAQs, Search Tips, Optimization, etc:

http://www.digitalhome.ca/forum/showthread.php?t=57741

07-31-2010, 02:18 AM

Pinza,

No, I use the aux for my avr. I was hoping it would work with the TV button. I did scan, but gave up. How many options does it scan? (What number of presses before I should give up?)

Also, can the VCR one be programmed to operate a DVD player?

It seems to me that all three buttons should be 'aux' buttons that can run anything, and not only to do TV, VCR, and only one aux.

07-31-2010, 03:27 AM

Unfortunately, some of the newer equipment is not supported by the older firmware in most remotes.

When asking for help or codes, please mention the model and revision of you remote, printed on the label on the underside.

07-31-2010, 03:37 AM

Try using a short legnth of RG6 coax for the time being.

Welcome to Discuss Everything Forums...

Tags for this Thread

Thread: Programming BellTV Remotes

Thread Tools

Rate This Thread

Display