Thread: channel troubles

i have a 5900. is it normal that the hard drive spin for about ten minutes before showing my channels guide than turn off by itself, than says attention, please stand by for satellite signal. than said transpondor 30. 1 to 5....

because it does that almost everyday!!!

That is NOT normal at all.

Try unplugging for a couple of minutes then let it go through all the hoops to reset itself.

Running a "Check Switch" after all that might also be a good idea.

yesterday i check my switch it said everything is alright. so now don't know what to do no more.... also, did a hard reboot like the technician told me so when i move to my new place. i mark it down on a piece of papar.

now my channels works. don't know why it wasn,t working before!!!!

from experience running a checkswitch usually resolves the problem

Could somebody tell me why when I turn my receiver on the volume on the channel I am watching is not as loud as when I am just watching Antenna TV.
Also why are some channel louder than others. I am continuously adjusting the volume whenever I change the channel.

Welcome to the Bell TV Volume Hell......lol

This is generally caused be Bell not adjusting the volume levels at the uplink station in Toronto. I have complained about this for years, it drives us nuts in this household, volumes go UP during Commercials and on HD Channels.

Hopefully, Bell will invest in a new automatic system to handle this in 2010 but do not hold your breathe.