Unlocking Siemens A62

08-01-2010, 03:35 AM

Yes, TP is the same.

08-01-2010, 12:36 PM

WRONG!!! TP is like mc60! It is not like A60 or C60!!! BE CAREFULL!!!

08-01-2010, 01:25 PM

You are wrong, my friend! It will work with MC60 testpoint, but it will work also with A60/C60 testpoint!
Tested and 100% working with A60/C60 testpoint!

It seems you have so much to learn!!!

08-01-2010, 04:12 PM

u are right about learning, but TP is not 100% same like on C60. Small diferent in lines, and in A62 there are 2 lines on the place where need to cut, and more difficult to cut, then it is on C60. Take the board and look through with strong light source, and u will see what i am talking about!

I am sorry, but I did not want to say anything bad for expert Chris02 or anybody else, just try to worn and share experience.

BR.

08-01-2010, 07:15 PM

Ok Guys Just
Clear me with Flash Reading...
When We get any Good Phone.
and If we want to Read its Flash which type of Boot We Should Select.
Bootcore Bug
or
Normal Boot.
and One thing More Does Phone Software Version , Flash Chip Type Puts any Special Diffrence?
Awaiting For Smart Ones Reply...
BR.

08-04-2010, 05:30 PM

@ nbene :
You are right, after all... For good testpoint, you must hold the PCB in front of a strong light, and you will see the lines.. Only one line must be cutted! You can do that cut with a surgical needle!

You must use testpoint.. After testpoint, Bootcore Bug or Normal mode will have the same results! Bootcore Bug can be used with old version of phones without TestPoint (Like A50 under v10, od A55 under v11)

**diwana** · 12-29-2011, 06:09 AM

Using the codes you can unlock your mobile because its safe for your mobile.......
Get the unlock code for your siemens model mobile through this site Theunlockspot.com , here it gives the unlock code along with easy instructions for your mobile.........