Thread: Boot problem with Freia

Hello there,

I'm trying to unlock my SX1 phone lock using freia, and with an unoriginal cable.

Freia reads my SX1 but it then says



why that bootcode error? how to fix it? i have tried with the 3 different types of bootcores but same thing.

Many thanks

Make Testpoint is needed

yes, the err show "bootfile is not accepted"

to fix it just ,make tes point .use friea 15 ,is good

Actually this is what im using , but where is the testpoint there

The Sx1 testpoint is so old stuff, that we can't remember at all!
Hahahahaha!

Maybe using the SEARCH feature will help you!
And you are in wrong section! Go to E-Gold section!

Okay i have found some picuters, i guess test point means hand working with hardware and it is not something with softwares.

But i don't understand the term CUT how to cut it ? does a blade do that :P? or i have to go to some electronic maintainance shop?


*Sorry about the E-Gold, i just donno if it is E or S lol !! i guess a moderator should move this post.

It`s E-Gold ... Freia does NOT support S-Gold phones

So I moved it in the right section



Regards,
B

I have removed the test point from the board, but it still gives me the same error


it seems i cut something near the testpoint as i was looking at the old board pic :S what would that cause :S , the phone turns on fine :S

Sorry for the double post but it is critical :S .
It seems like the CUT part is under the procerssor, how can i remove the processor to reach that area?

*The phone turns on, even tho if that thing i have removed from inside !! :S hope it doesn't ruin something else