Hi, I have a question as to what happens if I hook up my Rockford Fosgate 800a2 2 channel amp to my Alpine type X DVC sub. When bridged, I understand that I will load the sub at 4 ohms. What happens if I run both the channels to the sub? like use the + - on channel 1 of the amp to the + - on channel 1 of the sub and the + - on channel 2 of the amp to the + - on channel 2 of the sub?
Tags for this Thread
+ Reply to Thread
Results 1 to 1 of 1
-
11-19-2010, 07:03 AM #1
Junior Member
Status- Offline
Join Date- Nov 2010
Posts- 2
Downloads- 0
Uploads- 0
Car audio - 2 channel amp to a 4 ohm dvc sub.?
ReplyThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
If I have a 250 watt RMS amp at 4 ohm impedence, would it run a 2 ohm DVC 800
By A Miller in forum Car AudioReplies: 0Last Post: 12-28-2010, 06:35 AM -
Car audio - 2 channel amp to a 4 ohm dvc sub.?
By luigi m in forum Car AudioReplies: 0Last Post: 11-19-2010, 07:03 AM -
Can a Kenwood KAC 9104D amp push a 15" kicker L7 2 ohm dvc wired at 1 ohm?
By Blake West in forum Car AudioReplies: 0Last Post: 11-05-2010, 03:46 AM -
How do i bridge a Kicker l7 15 4 ohm sub (dvc) to a two channel amplifier?
By Javi R in forum Car AudioReplies: 0Last Post: 10-01-2009, 06:31 PM -
how do i hook up 1, 4 ohm dvc sub to make 2ohms on my 2 channel amp?
By Jerry P in forum Car AudioReplies: 0Last Post: 03-17-2009, 12:15 PM
Bookmarks