Thread: Repair ALL SX1 here

use variant patched original (offical) swup

...replace Charging C-MOS IC V2800 (manufacture code: SI5933DC).
For pcb placemment, go to http://www.shrak-mobile.com/eng/schem_siemens.html and open page 13.
dagos

thank's dud... i'll try this solution... thank's again

@ mysticmist

Sure, shorter and phisically easier is to take the phone to the Mobile Service Center, and pay a little

...I have here one SX1 wich come to me one month before, I do WinSwup and phone working OK untill now. Now only SiemensMobile at the startup...I can flash hem with any tool, WinSwup goes just fine but result is the same...only SiemensMobile....??????

URGENT NEED SYMBIAN FULL Flash file 32Mb (with loader for V-Klay), THERE WAS A THREATA BOUT THIS FILE BUT LINK IS BROKEN, MY PHONE SAYS BIZZZ, I FLASHED FULL WITH JOKER AND FREIA NO RESULT, PLEASE HELP!
REGARDS

sorry, i have died sx1. i fullflash with joker n freia still died. but if i start on can ear sound low batre but no any display in lcd. what must i do it?

sorry im too busy with many cases repairing phone and i forgot to read this forum. but phone problem not solved yet and i found another cases and i think i will need that symbian file. can you upload again..?
many thanks hacktek


fastlink

thaks soo much by this solution my phone its dead and now revive thanks a lot

@ hallo

Press and hold buttons:

Code:

 * + # + Power On

You`ll see =============== on screen (Formatting)

Battery must be well charged of course !


Regards,
B