Thread: Remote Address

I cant seem to find my manuals anywhere for my 2700 recievers.

Is it possible to change the remote addresses on them? If so how? I am using the blue button remotes on them if that helps.

1. Press and hold the SAT mode button about three
seconds, until all the mode button backlights
come on, and then release the SAT button.

2. Use the number buttons to enter a number
from 1 to 15. The SAT mode button backlight
will blink off after you enter each digit, and then
come on again.

3. Press the Pound (#) button. If the address you
entered is valid for the remote control, the SAT
mode button backlight flashes three times.

4. Press the Record button.

Great thanks. Will I have to change anything for the reciever? Or just the actual remote?

Just the remote.

or try pressing the record button on the remote, again, and again, and again.... until it controls the box

To change the receiver address, you need to go to the Sysinfo screen on the receiver and press record on the remote. You should see the remote address number change to match the remote.